PR-05, Power Rail

PR-05, Power RailPower Rail PR 05 Alternative power supply Nominal current 4 A Simple installation Standard length 50 cm, can be shortened to any length in 4 cm steps Terminating insulation by end cap, included in the delivery package With 2 leads for power supply, 2 leads for bus connections and 1 lead for centralized error messages or HART signal transfer (with RPI system) The Power Rail is a simple plastic insert for the DIN mounting rail according to EN 60715. It

Selectable mode of operation

140 °F) Degree of protection IP20 Connection screw terminals Mass approx

A separate fault output on the bus is signaled

It is a Profibus Slave

The new iFlex™ flexible current probe (included) expands the measurement range to 2500 A ac while providing increased display flexibility

in order to remove and prevent flammable gas or vapor accumulations

When applied to a steam trap

register addresses

Using non-intrusive technology combined with ISA100

T910 can be configured to publish measurements according to a time schedule or level triggered

) Output Contact loading 253 V AC/2 A/cos φ > 0

Two relays and an active 0/4 mA to 20 mA current source are available as outputs